Road Glide banner

Tackled Plasma Rod Install today

4K views 7 replies 5 participants last post by  jimmyray11349 
#1 ·
Thanks to all that have done this and posted tips and pics. Truthfully, it wasn't too bad installing, just tedious little work. I used 3/4" plastic quarter round and some extra strength double-sided tape to hold them in place.

Custom Dynamics parts were:
GEN-MPLASMA-RED - 8" Plasma Rods
TFC-3 - Plasma Rod Dual Converter X2
MAGIC-STROBES-SS6 GEN2 - Magic Brake Light Flasher

My only problem I need to fix and now fender skirt holding the tri-bar light seems loose and rattles, but the bolt is tight???

Anyway, here are some pics:
 

Attachments

See less See more
2
#6 ·
Plasma Rods are $129.95 pair
Brake light flasher $44.95
Plasma Rod Dual Converter $4.95 Each ($9.90 for 2)
3/4" corner round molding $5.88 Lowes
Scotch Exterior Mounting Tape $5.38 Lowes

Total: $151.11 without flasher / $196.06 with flasher

I'll get some pics up at night
 
#8 ·
I have this same set up plus I added a plazma rod below tour pak in the center. I am thinking of changing the one below the tour pak to amber. I wish CD made the amber in a 14" length. I like the CD products. I get lots of compliments on the brightness. I set my strobe to flash every 3-4 seconds when brake applied.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top