Road Glide banner

What did you do to your Road Glide Today?

3M views 22K replies 2K participants last post by  Roosterman623 
#1 ·
I've seen these threads on other forums, and they can go on forever. Just some place to post what you might have done in any particular day.

I'll start with this past weekend. I went out Sunday morning intending to ride down the road, any road. When the first 40mph gust of wind hit me, I changed my mind and headed over to Iron Pony instead. It being early Sunday, and the service dept was open, I decided to get the new tires I was needing. So, a few dollars later I ended up with two new Dunlop American Elites and new pads on the front brakes. They were out of the Metzler ME880's, but these are new model Dunlops, and it appears they only make two sizes so far, both just happen to fit my bike. Web site says more sizes coming in 2011. Only have about 300 miles on them, but so far they seem to be good tires. Holds the wind well :D (Sunday was VERY windy, almost got blown over getting off the bike)

Next up, Progressive 940's are on the way.
 
#3,041 ·
Heh, yeah, it was 44 degrees this morning when I started out... I think that is cold now..didn't used to think cold was cold till stuff started freezin', guess i'm gettin' old too.
 
#3,042 ·
The plan for today....get the RH floorboard back on. And get the forks off in prep for Monotubes. Put the new clutch cable on in prep for the new bars. May go ahead and get the old bars off as well. And get the accessory plug installed in the left saddlebag.

Now....lets see how much of that I actually get done!
 
#3,044 ·
Added the Skull fuel door, timing cover, and Derby cover. :D Short ride to school and back, beautiful day to ride here but too many errands to run to go for a long ride. And we still have residual traffic from the people not gone yet from the race.
 
#3,054 ·
Installed BADLANDS Load Equalizer (5 minutes) came with the correct CVO plug & Play ~ no soldering for me ~ Installed Custom Dynamics front LED's ~ stay bright white till ya hit turn signal then turn Amber ~ Plug & Play also. Installed Front Fork Air Baffle in Black ~ loved it on my 10 Ultra LTD ~ have not tried it on the RG Yet but I'm sure it will help. A total of 30 minutes in the garage and I was happy with the results.... SemperFi ~ If ya get the Front Fork air baffle be sure to get the screws, they do not come with it and required a putt to the HD shop to get them (a little annoyed with this)...
 
#3,057 ·
Installed my newly powder coated console and axle caps. Lost an axle cap coming home after getting a new tire. Mobile HD gave me a new set. Never a complaint about service there.
 
Top