Road Glide banner

Fairing Install

3K views 6 replies 3 participants last post by  dikdark 
#1 ·
OK so in trying to reinstall my fairing after making some changes and parts, I get it to lock in well except for a gap on both sides above the volt and fuel gauges. Have taken it back off and just cant figure out why it wont flush up, any tips or words of wisdom would be great
 
#4 ·
Can't remember for sure but i believe the outer fairing fins go in front of the inner fairing fins. If you have all the screws out you should have enough play to pull apart far enough to get them to where they need to go.
 
#5 ·
Ok checked fins they are correct still see nothing that should be keeping the top from flushing up, I never noticed it before but a 1/4 inch gap on both sides above the gauges cant be right. Stopped and looked at a new one last night but could not see or feel for the gap with the factory winshield on. Maybe this is silly but could my Klock Werks windshield be causing a problem or is there something thats suppose to be there, thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top