Road Glide Forums - View Single Post - How to properly install 14" Paul Yaffe Monkey Bars on my '06 RG
View Single Post
post #5 of (permalink) Old 01-07-2017, 04:49 AM
madmat
Life Member
 
madmat's Avatar
 
Join Date: Jun 2012
Location: Mass
Posts: 4,010
Garage
Quote:
Originally Posted by WTFranz View Post
I put these same bars on my 2016 and offer the following after doing mine 2x

1. Take your time and don't rush, keep the excitement contained...LOL
I failed my first attempt due to this!
2. Remove the entire stock bars and controls off the bike and more to a well lit bench or in my case kitchen table
3. Not sure if your 06 has eThrottle or not but with the sharp bends in the bar I had to remove the heavy black wire covers of the Throttle control and hand controls on the right side to get them through the bars nicely and not damage wires.
4. Use ball chain as a wire pull.
5. Get everything remounted and wires run and taped out of the way for remount to the bike.
6. Prior to buttoning everything up turn the bike on and test all controls and start.

Hope this helps... You will love the bars and the look.
All the above is great stuff, I would add:

Push/pull, push a couple inches in-pull a couple out
Lots of lube
Patience, don't be afraid to walk away and come back later

Great bars, you will love the results!!!


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

18 RGS Bonneville Salt Pearl
madmat is offline  
 
 
For the best viewing experience please update your browser to Google Chrome