Road Glide banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Aftermarket Accessories
    I am in the process of a build and bought a Brocks Performance West Coast Bagger swing arm. The finish black powder coating looked like a 2 year old with a crayon finished it. Brocks was contacted and their response was, oh well, we can't send another for weeks so here's $200 take it or leave...
  2. *General Road Glide Discussions/Pictures
    Guys, I decided to focus on my 2012 Roadglide for my winter project, I retired the 103 and installed a new S&S 124 with a Power Vision Tuner. I am now in the break in and early tuning process. One thing I knew I didn’t want was the external oil lines from the engine that would require a jig and...
  3. *General Road Glide Discussions/Pictures
    Guys, I'm gonna breath some life into my 2012 Road Glide with the S&S 124. There seem to be quite a few installed in Dressers n RG's, so wondering if you have installed an S&S 124 did you run external oil lines, or did you drill the block? Id like to tap the forum experiences here before I...
  4. Engine Related
    Just pulled the trigger on an S&S 124 lc for my 2012 RoadGlide. Weighing options. If you've installed a 124, Did you run lines or drill the case? Any regrets? Appreciate any feedback, Thanks, Doug
  5. Intake and Exhaust
    Hey guys.. just got a 19 RGS and looking to get slip-ons.. been racking my head over two - Race Pro or MK45s - they both have a sound I like (deep and throaty rumble) - they both about same price (diff of 15 negligible bucks) - so questions is... in ones opinion or experience... does one give...
  6. Engine Related
    Just finished my first Harley engine rebuild and these are my thoughts on the whole thing, forgive me if my writing aint the best but i never cared for English class very much (bad teachers? :grin:) Build run-down: 2006 FTRI 72,000 miles -S&S 4" crank+ SE lefty bearings -SE 95" Std Flat tops...
  7. Engine Related
    Now here is going to be a good discussion I hope. As I had said, I am building a 117" engine and looking for as much input from people as I can. For this poll, I am curious on which cases I should go with? I struggle with the criteria that I have set and for this engine, the main criteria is...
  8. Sold
    Bought this motor for my bar hopper but the bike runs so good as it is I decided to leave well enough alone & didn't use it, It has been in heated storage ( my living room) since day one .... its missing The carburetor and manifold I planed on using a Mikuni and the push rods & ignition which I...
1-8 of 8 Results
Top