Road Glide banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,034 Posts
Discussion Starter #1
Hi everyone, I had my bike serviced at the local MoCo-store. It turns out the tech there must have been in a hurry. When I took off the right side-cover all the wiring was hanging loose like coocked spaghetti... I tried to the best of my knowledge to put everything in place. But I couldn't figure one connector (marked with a red circle) photo#1. I'm still not sure if I got everything sorted out (photo#2) - anyone?
 

Attachments

·
Registered
Joined
·
8,856 Posts
What was he doing under your R side cover?
 

·
Registered
Joined
·
1,034 Posts
Discussion Starter #3
Hi, Big Gary! Sorry for the late reply (been busy with the huge NATO MILEX Trident Juncture).
To your question - I had the bike at the local MoCo-shop for a run on the Dyno. I had changed the headers & mufflers and it wasn't right (the air/fuel mix was too rich). I have a PCIII USB hooked up to the M&M EFI. What's more I think the dude at the shop only spent about 2 hours on the bike. He didn't do a thorough tune, probably just hooked up his laptop to the PCIII and changed the tables for adjustment... and to add insult to injury left all the cables in a shambles! :(
 
1 - 3 of 3 Posts
Top