Road Glide banner

98 RG single post turn signal to newer 2 post fitment?

1157 Views 3 Replies 2 Participants Last post by  Eagle
Howdy all,

I'm going to be putting ghost brackets on my '98 RG but have noticed that the turn signals from that year were a single post that mount on the fairing support brackets a little under the fairing. Removing that support bracket also remove the mount for the front turn signals. I was wondering if the later year turn signals (those with the 2 posts that go through the fairing) will fit on a '98 fairing (assuming the wiring is the same)?

Worse case scenario I can just cut the fair support brackets and have the turn signals mount just below the fairing: Go hacksaw and dremel on those bad boys haha :D.

Many thanks,
1 - 2 of 4 Posts
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.