Road Glide banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
1 - 2 of 2 Posts

· Registered
Joined
·
1,205 Posts
Discussion Starter · #1 ·
OK, getting ready to do my install. RF PBR300X2 (2 ohm), Infinity Kappas 62.11I (2 ohm) and FLTRU HK head unit (2 ohm). So I should be able to take the power wire off the speakers and route them to the input for the amp, then run the supplied speaker wires from the amp to each speaker with out worrying about worrying about wiring in parallel or series right? I'm only doing the front inner fairing speakers for now and if I decide to amp the rear tp speakers in the future, it should be the same, no?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top