Road Glide banner

1 - 9 of 9 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter #1
Got my prewired switches and tbw in the bars
late this afternoon. Raining here in memphis so
i figure tomorrow good time to tear the shark down and install
bars. Putting wires in not to hard i did left by myself
and had wife help on the the right. TOOK ABOUT 1 HOUR
Pics to follow along with install
 

·
Registered
Joined
·
1,870 Posts
Always up for a handlebar install. What size did you go with? Looking forward to seeing the pics.
 

·
Super Moderator
Joined
·
12,428 Posts
Getting the wires through the bars is the hardest part IMO, the rest is easy, looking forward to the pics.
 

·
Registered
Joined
·
87 Posts
Discussion Starter #5
Well i am deep into the install had to take break putting switches back together is killing me here are a few pics
amps and the shitty job radio installer did will never let anyone mess with my bike again i have to do alot of clean up
 

Attachments

·
Registered
Joined
·
279 Posts
HOLY SH*T! Birds nest in there! I would be right back at the installer to give them a word! Good luck with that!
 

·
Registered
Joined
·
87 Posts
Discussion Starter #8
yeah holy sh## is right
i straightened it up best i could
almost done bars are complete except for redoing brake lines
also going to redo routing of clutch from where i put it
be calm i am novice at all this
but here is a pic of birds nest with a little work
 

Attachments

·
Registered
Joined
·
87 Posts
Discussion Starter #9
also best thing is everything works first try except
volume control is upside down up is down and down is up
not bad for a rookie
 
1 - 9 of 9 Posts
Top