Road Glide banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6,588 Posts
Discussion Starter #1
I got a set of 103 cylinders that already been bored .010 over and I was thinking about boring them out to 106 or 107. Has anyone done this and is the 103 cylinder walls thick enough to be bored to 106/107?
 

·
Registered
Joined
·
941 Posts
I got a set of 103 cylinders that already been bored .010 over and I was thinking about boring them out to 106 or 107. Has anyone done this and is the 103 cylinder walls thick enough to be bored to 106/107?
Like you, I have an '08. You are considering going to a 107" by way of your temporary stop at. 103".
I've been considering jumping straight into 107".
 

·
Registered
Joined
·
6,588 Posts
Discussion Starter #4
Not sure if I want to go with a 106/107 yet. I just put on new 103 cylinders not to long ago but these cylinders are just sitting here and since they are already .010 over I would have to hone them to reinstall which may make them a bit too big. Boring them to a 106/107 would be the best so I can use them the next time I freshen the top end or if I want to sell the cylinders it would be easier.
 
1 - 5 of 5 Posts
Top