Road Glide banner

1 - 6 of 6 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1 (Edited)
SOLD.........FS Heritage bars

I have a set of Heritage bars for sale off my 2006 Road Glide. Had them on for 2 years but now am going with a set of apes. They are not scratched or bent but look just normal as a 2 year old set would look. Would like $35.00 of best offer.
kruzin
 

·
Registered
Joined
·
23 Posts
Discussion Starter #3
I am out traveling today but yes, I do have the part number at home. As far as the difference they have maybe 1.5 - 2 inches of rise over the RG bars. You are still able to use the same clutch and throttle cables, do not need wire extensions and the brake line will fit but it took just a little "adjustment" to make it work.

I will post the part number when I get home. I also looked up the bar measurements and will post that also.
 

·
Registered
Joined
·
23 Posts
Discussion Starter #4
The Heritage bar part number is 56569-86. The measurements are: Tip to tip=31.25, Pull Back=5.0 and rise=12.0. Hope this helps.
 

·
Registered
Joined
·
23 Posts
Discussion Starter #6 (Edited)
For what it's worth I am going to a slightly taller bar with just a tad bit more pull back than the Heritage bar. Just seemed to be a better fit as I have my tour pack in the solo position so I can just lay back and cruise. If I could post pictures I'd show you what I have. Was able to use the same stock clutch and throttle cables. I did need to change the brake line tho. Not all that bad as I wanted to get a braided line anyway.

By the way the bar I used is from J&P cycles part number 5000829.

Now that I gave this information out probably killed any chance of selling my Heritage bars. Oh well...................
 
1 - 6 of 6 Posts
Top