Road Glide banner

1 - 3 of 3 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter #1
Just a heads up on using the CV B52 AMP, the Daymakers will hit the AMP and not allow the fairing to seat properly if the AMP is mounted as shown. Had to trim down 2 of the heat sink fins on the Daymakers backside to get them to clear the AMP, see photo link below:

https://photos.app.goo.gl/ZyqrTTXcnXqGX98y9
 

·
Registered
Joined
·
1,226 Posts
Have you considered mounting the amp with Velcro between the glove box and fairing?
 

·
Registered
Joined
·
130 Posts
Discussion Starter #3
Have you considered mounting the amp with Velcro between the glove box and fairing?
Yep, matter of fact that's where it was originally gonna but, I felt more secure with a hard mount......that'll teach me. Install is finished anyways so it's water over the dam at this stage. Just thought I'd FYI anybody else doing this same setup.
 
1 - 3 of 3 Posts
Top