Joined
·
173 Posts
Hey guys and gals,
This year after spring opening, I have started to experience some hesitation and pops, and was wondering what you would look at.
I open every spring with the following:
New plugs
Oil / filter
I also did, this spring:
Primary oil <when I did my M6 chain lifter>
Transmission oil
Even before the primary and tranny fluid, I was getting pops and hesitation. The pops happen on accel or decel, but mostly decel and the hesitation almost always happens on decel at 3k or more RPM's. I have been through multiple tanks of gas and almost exclusively run non ethanol gas. When I don't have a choice I also add stabilizer with ethanol remover. I almost never run my gas below a 1/4 tank and semi regularly use Lucas to keep things clean.
I have checked for codes and there are none in any of the categories.
I am at 19k on a 2011 and as far as I know the fuel filter has never been done (if this is a possibility)
After checking gap on my plugs they sat on my tool bench for a week or so and I didn't re-check them before putting them in, so I may look at those, but anything else you would look at specifically? Thanks for any input.
This year after spring opening, I have started to experience some hesitation and pops, and was wondering what you would look at.
I open every spring with the following:
New plugs
Oil / filter
I also did, this spring:
Primary oil <when I did my M6 chain lifter>
Transmission oil
Even before the primary and tranny fluid, I was getting pops and hesitation. The pops happen on accel or decel, but mostly decel and the hesitation almost always happens on decel at 3k or more RPM's. I have been through multiple tanks of gas and almost exclusively run non ethanol gas. When I don't have a choice I also add stabilizer with ethanol remover. I almost never run my gas below a 1/4 tank and semi regularly use Lucas to keep things clean.
I have checked for codes and there are none in any of the categories.
I am at 19k on a 2011 and as far as I know the fuel filter has never been done (if this is a possibility)
After checking gap on my plugs they sat on my tool bench for a week or so and I didn't re-check them before putting them in, so I may look at those, but anything else you would look at specifically? Thanks for any input.