Road Glide banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
1 - 4 of 4 Posts

· Registered
Joined
·
815 Posts
Discussion Starter · #1 ·
Well need some advice. Im trying to install my new hidden front axle and wheel but currently the captive nut is stuck and I can not get it to move any more. It is about a 1/4" from being seated. I obviously cant remove it either at this point. Any advice or help is appreciated.
 

· Registered
2021 Ducati Multistrada V4S
Joined
·
4,526 Posts
You can remove it. Just put the bolt back in it all the way and tap the bolt with a hammer. It will come right out and then you may be able to see what is causing it to not seat properly.
 

· Registered
Joined
·
815 Posts
Discussion Starter · #3 ·
Thanks for the tip RGken. I was able to get it back out cleaned the hole up a little bit with some sand paper and got it seated.
 
  • Like
Reactions: RGKen
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top