Road Glide banner
1 - 1 of 1 Posts

· Registered
58 Posts
Discussion Starter · #1 ·
Getting to the point where you cut the spacers, (directions leave a lot to be desired)! Paper directions say cut at top of tube flush). But on the box lid it states to cut off 1/2" above the tube and for aggressive riders cut at 3/4" above tube (for more off-road. I hate it when there's discrepancies on instructions!
Also they say to remove any emulators? I wouldn't know one if it bit me in the ass! I assume thats the little "do be careful" that falls out under the stock spring with a steel ring on the piston?
I think I may go by the stickers on the box lid with a 1/2" beyond the tube. Will be a PITA to compress and start the threaded plug?
Anybody done these yet? Thanks for any help!
1 - 1 of 1 Posts