Road Glide banner

Jac Knife Highway peg install

8310 Views 9 Replies 5 Participants Last post by  DED HD
I have been trying to decide what type of highway peg to use and found these. After viewing the video and the printed instructions I still had some questions but figured it out as I went. I am very happy with the quality of the components; the machining is very precise. This is not meant to be step by step, this is just supplemental to show some more detail. Here are some pictures of my installation:

The biggest task is to grind existing material off the floor board supports. The arrows show the areas to remove material from

The areas inside the boxes show the supports ground down to provide proper clearance for the peg assembly.
The following photos show the complete installation:

I'm 5'9" with a 29 inch inseam so I would need some serious offset to reach engine guard mounted pegs. The Jac Knife pegs give me a chance to stretch my legs out straight.
See less See more
1 - 1 of 10 Posts
Those look pretty badass. I am pretty short, so attaching highway pegs to my crash bars wouldn't really do anything for me. Where did you get them?
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.