Road Glide banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 6 of 6 Posts

·
Registered
Joined
·
272 Posts
Discussion Starter · #1 ·
I have performed the mods to accept the VTWIN Splash Guard per the instruction. On there is shows that the HW mount will then sit flush, I can not for the life of me get this flush! I have only tried by myself but maybe if someone was pushing from front while I pulled the back? Is it supposed to be that tight? Radio and mount are in the exact same position that they were in before mod but they do have room to move back.
 

·
Registered
Joined
·
272 Posts
Discussion Starter · #4 ·
Lol, Well I took the rubber o ring off the HW mount and it slides right in........ But then the radio is too deep I feel and I am not running without oring I was just checking.

IDK I may just buy their mount and sell the HW.
 
1 - 6 of 6 Posts
Top