Road Glide banner

1 - 2 of 2 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
Hey everyone. I'm sure it's been asked, but I can't find it anywhere. The mpak 12 is plug and play for the fairing and I see where the speakers disconnect with a two pin molex plug. Where do the rear, tour Pak speakers wire in to the kit/amp? I'm on a road glide ultra.
 

·
Registered
Joined
·
1,671 Posts
Try this series on you tube? https://www.youtube.com/watch?v=-pAYeNqfxFY&t=7s
.I was looking at this system and was planning on getting the biketronics BT-BOC harness for the rear and two BT355 line levelers...I thought (could be wrong) that the MPAK 12 addresses the fronts only and you either have to run new wires, or use the BT-BOC for plug and play (or splice, nah!)...It does only come with 2 speakers!!....again, I wish I had the kit so I could tell you for sure..the audiophiles here will join in soon!!!
 
1 - 2 of 2 Posts
Top