[Papagonza]

Question..I have a 19 Road Glide Special and am changing the engine guard to a smaller mustache type. The support that comes down from the fairing will not reach the new bar. Is it necessary and can it be removed without effecting the turn signal? Thanks

 

[texasnurse]

Yes it is necessary for support. Here is the roadglide model

https://mstore.harley-davidson.com/store/chopped-engine-guard-pa-07-49000117a--1


Sent from my iPhone using Tapatalk

 

[Papagonza]

Thanks but, I don’t see where the support in question
attaches to the chopped bar.

 

[texasnurse]

Thanks but, I don’t see where the support in question

attaches to the chopped bar.

The Harley version attaches directly to frame.
See more info/instructions


Sent from my iPhone using Tapatalk

 

[Papagonza]

Thanks again texasnurse but, I am not using the Harley chopped bar.

 

[RFG7680]

Thanks but, I don’t see where the support in question
attaches to the chopped bar.

It does not attach to the lower guard or the mustache guard. Look at the top bracket in the picture. It mounts the the original crash bar tab in the center of the frame. Then to the fairing. You need that bracket.

 

[texasnurse]

Thanks again texasnurse but, I am not using the Harley chopped bar.

Fab time


Sent from my iPhone using Tapatalk

 

[UT_Larry]

http://store.hellsfoundry.com/hffltfs15b.aspx
I think this would work for you. You do need to have supports. They also make brackets that allow you to change where the fairing sits. I would use there contact us page and send them an email.