Road Glide banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
Hey Guys Have a 13 RGU, and I notice I have some Oil coming out of the Head Bolts for the Air cleaner. I Know there is a O-ring in there.(Maybe put a new O-ring in and re torq?) I have the Big Sucker Air cleaner on. And I'm already 1/2 quart low. Any idea's. It is not Bad but does bug a guy.
 

·
Registered
Joined
·
378 Posts
I have a 2012 RGC that had a big sucker and had the same issue, couldn't get it to stop. I replaced it with the V&H Naked because it has the tubes to redirect the blow by back into the intake. Never had the issue again.
 

·
Registered
Joined
·
734 Posts
I had the same problem with the SE Ventilator. The backplate of the ventilator would vent the blowback into the filter causing it to become saturated with oil and eventually began dripping all over my shinny chrome..

I bought new breather bolts that have the nipple on the end and drilled a hole in the back plate to run tubing to the ground...
Auto part Engine Fuel line Vehicle Carburetor
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top