Road Glide banner

1 - 7 of 7 Posts

·
Registered
Joined
·
848 Posts
Discussion Starter #1 (Edited)
SOLD!!! For 15-newer Road Glides. Just swapped out these bars for the 14” Kliphangers; I reused the hardware from these on the 14’s so you get the new hardware hermetically sealed in the box. The “U” portion has less than 200 miles on them. New price is $459, asking $300, I’ll pay shipping to Continental US.



Comparison between the 10” and 14”:




Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
169 Posts
Great bars. If anyone wants 10" jump on this.

I installed the 14s on my bike over the winter. Being able to adjust the wrist angle is VERY nice along with being able to install the grips part with an up or down angle.
 

·
Registered
Joined
·
848 Posts
Discussion Starter #5
Do you happen to know why this wouldn't fit a pre Rushmore bike ?

1. The diameter of the bar at the riser is 1-1/4” versus 1” on the pre-Rushmore’s, so a new riser would be needed, and

2. The hand control pieces are different in hole placement and the pins.

KlockWerks does make pre-Rushmore Kliphangers, which I installed on my former 2013 RGU...


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
848 Posts
Discussion Starter #7 (Edited)
SOLD!!! Thanks Dom!!!


Sent from my iPhone using Tapatalk
 
1 - 7 of 7 Posts
Top