Road Glide banner

1 - 5 of 5 Posts

508 Posts
Discussion Starter #1
I keep 2 Freewire within the tourpack, to secure them I was using Velcro and glue but it was barely sufficient and messed up the liner as well.
Looking at the tourpack I realized I had available the right speaker grid and the 12v plug available as support.

Being in lockdown I took the time to design a proper support

8 hours to 3d print the part

Installation went fine, a tie-rap secures the installation

Put the freewires in, now I have a very clean and secure installation

If anybody is interested, files are here: PrusaPrinters

Inviato dal mio iPhone utilizzando Tapatalk
1 - 5 of 5 Posts