[Norfra]

I suspect the speaker pods (under the Tour-Pak backrest) would connect to the 12 pin connector (under the seat) that the saddlebag speakers connect to.

The two bottom left and two top right.

For the saddlebag speaker install you disassemble the 12 pin connector and take out the 4 "blank" nylon pins on the 12 pin connector and push the 2 each side (right & left) Harley provided harness pins into the back of the connector until they "click" in. There was no soldering or splicing involved. I have no idea what harnesses comes with the speaker pods.

I took a couple pictures below:

L2

View attachment 490696

View attachment 490698

View attachment 490699

Thanks for the quick reply
Which one is pos and neg ? Or does it mater

 

[Norfra]

On the harness I got from Harley has red wires with one set of wires have a black strip and the other set has a grey strip .
Sorry to be a pest as I am not good when it comes to electrical.
Unable to take bike into Harley as it is winter here in Manitoba Canada

 

[Norfra]

I've never seen the speaker pod wiring harnesses, only the saddlebag harnesses. Do you have the instruction sheet that came with the speakers? It should be marked there what the wires are.

L2

No nothing.. Harley said it is a saddlebag harness which can be use for the speaker pods ??
Can I assume the red wire with the black strip positive
Red wire with grey strip positive

 

[Norfra]

I've never seen the speaker pod wiring harnesses, only the saddlebag harnesses. Do you have the instruction sheet that came with the speakers? It should be marked there what the wires are.

L2

Thank you I will check it out

 

[Norfra]

Most speakers have 2 spade type connectors on them. And usually the positive is the narrower one, negative is wider. Can you follow them from the spade connectors to see what polarity is what color/striped wire?

L2

I will do that .. thanks